Contemporary Styling And Sanding Parquet

February 16th, 2015 by Rosemary
Comments Off on Contemporary Styling And Sanding Parquet

Modern parquet laying as follows – hardwood dowel fit into a special parquet glue and nail a galvanized nail or pin with parquet air gun, leaving technological gap between the wall and flooring 1-1,5 cm When laying parquet instead of nails, screws are used that are screwed in steps of 20-30cm. Floorboards tight joints and are glued to the parquet glue, and a gap near the wall about 1 cm if the width of the board exceeds 15 cm, then the screws screwed also on the front side, which in future can disguise a special tube from the same tree. Complex parquet works by sanding parquet consists of the following steps. Sanding hardwood floor sander drum-type SB-206. Gap chips mixed with filler. Next, apply sander trio (Surface) to achieve a perfectly flat surface. In remote places (under barathea, in corners, etc.), hardwood floor sanding machine performed Flip.

Then, the floor re-sanded surface grinding machine trio. It was only later applied lacquer, after drying the first layer surface of the processed single-disc machine columbus, designed for fine grinding, thus removing lint and small vesicles. After that, a perfectly flat surface with a thin layer of lacquer in 2 layers. Now, sanding and parquet can be regarded as complete.

Posted in General

Comments are closed.